Question...

[Destroyer]

Ok, that's what I was missing.. I thought that it would use a new 1 piece driveshaft, not an extension piece on the existing 20". Makes perfect sense to me now. No way would I want a 2 part driveshaft.. sounds like it's just asking for trouble that way.

Now, the question is, which way to go... Jackplate or extension?

[spareparts]

Merc uses two piece drive shafts on the service replacement lower units now, it may not sound great , but it works. There are a ton of used 25" lower around, 20's are hard to find. I've got a spacer on an older 2.0l, I'll see if I can get it off with out destroying it. I think I have a good 25" lower I'll trade you for a 20. Give me a little time on it, I still have this "other" boat in my back yard I've got to do something with

[Destroyer]

Originally Posted by spareparts

Merc uses two piece drive shafts on the service replacement lower units now, it may not sound great , but it works. There are a ton of used 25" lower around, 20's are hard to find. I've got a spacer on an older 2.0l, I'll see if I can get it off with out destroying it. I think I have a good 25" lower I'll trade you for a 20. Give me a little time on it, I still have this "other" boat in my back yard I've got to do something with

Sounds like a plan. I suspect that I'm going to find out where Goose Creek is sometime in my near future.

[phatdaddy]

here you go welcome to goose creek


http://www.youtube.com/watch?v=AClW-lJGXis

[Destroyer]

Originally Posted by phatdaddy

here you go welcome to goose creek


http://www.youtube.com/watch?v=AClW-lJGXis

Thank you