![]() |
|
|
|
#1
|
||||
|
||||
|
look up under the gunnels, there's spray foam in there. The boat is supposed to float level full of water, too much flotation in the bottom would make it flip over when full of water. I believe flotation was required up to 20 ft, so your V may not have any. We used to have a 20 Sea Ox, not a bit of foam in it, just a bunch of soggy wood
|
|
#2
|
||||
|
||||
|
I have seen three V20's in various stages of project on the floors, all three had foam around the fuel tank, two of them had some foam in the area near the junction of the hull bottom and the hull sides around mid ship and a little forward and a little around the back corners. Nothing I would call being foamed in.
One had just the foam around the tank.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW |
|
#3
|
|||
|
|||
|
Excellent feedback, I DID find foam around the fuel tank when I replace it during my restoration. However its the only area with foam period.
Here is a picture of her with 30 gallons of fuel, two batteries 100 lbs, 58 lb kicker, two full coolers with coolant and ice. She floats really high in my honest opinion..
|
|
#4
|
||||
|
||||
|
My 95 V21 had foam in the cavity between stringers and gunwales from bow to stern....that cavity wasn't FULL of foam, but had several inches of it sprayed/stuck to the bottom...wasn't OVERDONE that's for sure...w/rod-boxes out, you could see foam below where they sat...
And I must say, NY Mack...you sure got a PURDY V20!!...nice work!!...how 'bout some inside shots...what did you do around the front of the splashwell?...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha Last edited by reelapeelin; 06-09-2011 at 08:51 AM. |
|
#5
|
||||
|
||||
|
Floating high is right. You sure she isn't sitting on the bottom. LOL That V is looking better than ever.
1983 center console had foam a plenty like Reel's. Fuel tank was foamed plus the entire area outside of the center stringers front to rear. I shoveled it all out. It was dry, so I replaced it after glassing in a few replacement pieces. Foam had to stiffen up the hull a little, I could stand on it.
|
|
#6
|
||||
|
||||
|
My 84 has it around fuel tank, that's it.
And I agree that your boat seems to float unusually high. I thought maybe it was grounded or listing away from the camera Also, did you move the fuel fill? and the scuppers?
__________________
1984 V20 "Express" & 2003 Suzuki DF140 (SOLD!) 2000 GradyWhite 265 Express YouTube/SkunkBoat https://www.youtube.com/channel/UC4F...znGospVOD6EJuw Transom Rebuild https://www.youtube.com/watch?v=EEz94NbKCh0 https://www.youtube.com/watch?v=Oe_ZmPOUCNc Last edited by SkunkBoat; 06-11-2011 at 05:51 PM. Reason: more questions |
|
#7
|
||||
|
||||
|
Ok, total newb question here, (sorry for the high jack) what the heck are scuppers?
__________________
77' V20 There's no shirt like no shirt! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|