Stringer wood

[Blu_Lunch]

All the gurus here and nobody can give any advise?

[bassarama]

Originally Posted by Blu_Lunch

All the gurus here and nobody can give any advise?

I'm not one of those experts by no means...

I would pick a wood with small and tight grain like ipe/mahogany.

[nipper]

Not an expert by any means either, but when I did some stringer and floor work on my old 1972 Speedliner 17' boat I used 3/4" marine plywood. It was hard to find in my area of the country, and expensive.

[RidgeRunner]

I think Wellcraft used plywood for the stringers. I would use. 3/4" Marine Tech PT but Kiln Dried After Treatment or even untreated. You can use 3/4" BC FIR as a cheaper alternative. I would stay away from the tropical hardwoods like ipe and mahogony unless you are building a very nice wood deck. They are strong but cost prohibitive and I believe a little too stiff for a backbone in a fiberglass boat. Besides if it has a center stringer, you will need a piece that is at least 12" wide. That may be a tall order ($$$) in the hardwoods. Then there are composites. More money. If you need longer than an 8' run you make a nice scarf joint in the plywood and reinforce with glass.
What glass did you buy? and what is your layup schedule?

[Skools Out]

3/4 plywood and on the top add 2x2 to one side of your stringers to add a place to screw down your new floor.

[reelapeelin]

Can you pour up new stringer cores w/Arjay?...

[phatdaddy]

reel, they make a foam you can pour in it, cut the top off at the level you want and lay a glass strip over to seal. just get the rotten wod out and use the remaining glass as a mold.

[Blu_Lunch]

Originally Posted by RidgeRunner

I think Wellcraft used plywood for the stringers. I would use. 3/4" Marine Tech PT but Kiln Dried After Treatment or even untreated. You can use 3/4" BC FIR as a cheaper alternative. I would stay away from the tropical hardwoods like ipe and mahogony unless you are building a very nice wood deck. They are strong but cost prohibitive and I believe a little too stiff for a backbone in a fiberglass boat. Besides if it has a center stringer, you will need a piece that is at least 12" wide. That may be a tall order ($$$) in the hardwoods. Then there are composites. More money. If you need longer than an 8' run you make a nice scarf joint in the plywood and reinforce with glass.
What glass did you buy? and what is your layup schedule?

I bought West Systems 105 and 206 the stringer was just plain lumber I swear it is pine it was really cheap wood the deck was 4 by 4 plywood squares.

[Fitz]

Blu Lunch:

Did you pop the top or cut out the deck? I did a search for earlier posts but couldn't find anything. Any photos?


Fitz

[Blu_Lunch]

Originally Posted by Fitz

Blu Lunch:

Did you pop the top or cut out the deck? I did a search for earlier posts but couldn't find anything. Any photos?


Fitz

http://forums.iboats.com/showthread.php?t=404584