|
|
|
|
#1
|
|||
|
|||
Your V looks awesome, As for the VRO disconnect you need to cut the line about 3 inches down from the pump "oil in" as shown and plug it with a bolt and a hose clamp, Trace the wires from the pump to the harness and disconnect it. If the low oil warning is active you need to disconnect the sender and tape up all wires on mine its was a tan color.
|
|
#2
02-21-2011, 12:06 PM
|
||||
|
||||
|
Thanks mack.
|
|
#3
02-21-2011, 10:25 PM
|
||||
|
||||
|
Ran much smoother today with the harness unplugged. I think it's ready. Just a few other things to take care of, and I hope to have it in the water this weekend.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
