The Motor won't start??

[THEFERMANATOR]

DON'T MAKE ANY ADJUSTMENTS WITH IT OUT OF THE WATER!!!!!

I CANNOT stress this enough! You can set your link and sync on it, but don't change the idle speed. Your used to your old cross-flow engine, that early looper will change drastically when it is put in the water. Timing needs to be set to 18 BTDC @ 5000RPM's, and your in gear idle should be around 650-750. If you don't believe me about the engine changing when you put it in the water, put a block of wood over prop and block it off while it is running.