|
|
|
|
#1
|
||||
|
||||
Yeah, heat is the best. Strong hair dryer, or heat gun would be better. Then you can take a spray can of brake cleaner to remove the rest of the residue.
__________________
Captain Jon 
|
|
#2
05-06-2010, 05:59 AM
|
||||
|
||||
|
Leave it there...cut a piece of 1/4" Starboard to fit the area...it'll also kill out (cover) the screw holes and the hole under the clamshell...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#3
05-06-2010, 07:56 AM
|
||||
|
||||
|
Quote:
__________________
Heavily medicated for your protection.
|
|
#4
05-06-2010, 01:50 PM
|
||||
|
||||
|
I was thinking that. I need to re-do my dash as well, so I'll pick up a large enough sheet of stareboard to do that. I've seen it at West Marine, any suggestions on other potential (less $) options? WM tends to price pretty high, but I don't know who else carries that stuff
|
|
#5
05-06-2010, 02:14 PM
|
||||
|
||||
|
you could try looking up a local industrial type plastic supplier. not sure if they will deal in less than full sheets but it might be worth a try. I've had to buy a few sheets here and there for some customers and the one I use around us here sells them cheaper than retail.
__________________
1986 V-20 1986 Yamaha 150 HP
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
