Throttle/Shift Cables

[reelapeelin]

Like Spare said...Go w/the SUPREMES!!......don't wanna be scrimpin about that Purdy Lil 21

[Blue_Runner]

go ahead and splurge and get the "supreme cables". I've used the Uflex cables, they aren't as nice as the teleflex supreme, but they sure cost a lot less, and they get the job done.

See? This is why I ask....now I'm E-D-U-M-A-C-A-T-E-D!

So should I pull the old cables to get the length or just measure using the formula? Probably doesn't make a whole heck of a lot of difference either way huh?

[bradford]

Originally Posted by Blue_Runner

See? This is why I ask....now I'm E-D-U-M-A-C-A-T-E-D!

So should I pull the old cables to get the length or just measure using the formula? Probably doesn't make a whole heck of a lot of difference either way huh?

I'd pull the old ones or try to get a part # to cross reference the length. Don't want your cable to be an inch too short if ya know what I mean.

[Blue_Runner]

Zackly Bradford!

[spareparts]

length should be written on on end or the other. If not, tape a pice of rope on one end before you pull the cable out, try one at a time incase your rope coems off. That way, it will be easy to pull the new cables back in.

[Blue_Runner]

10-4 thank ya Spare!

[reelapeelin]

Originally Posted by spareparts

length should be written on on end or the other. If not, tape a pice of rope on one end before you pull the cable out, try one at a time incase your rope coems off. That way, it will be easy to pull the new cables back in.

In my best Foghorn Leghorn voice...The boy's smarter than a super computer on steroids...