|
|
|
|
#2
04-18-2010, 10:12 AM
|
||||
|
||||
Reel-
I probably missed it on one of the threads but what did you end up doing about the shaft length on the Honda? I remember you weren't sure if you were going to jack plate it or try and extend the one you had. -Svence
__________________
1984 V-20 Steplift 1998 Johnson 175 
|
|
#3
04-18-2010, 10:40 AM
|
||||
|
||||
|
You be pimpin' out da dash wit da starboard stuff..............
Nice job looks great.............
__________________
1974 Wellcraft V-20 Center Console 1999 Mercury 150 HP Bluewater 1975 Wellcraft V-17 1977 Evinrude 70 HP Restoration Thread http://forums.iboats.com/showthread.php?t=404584 Enfield Connecticut Civil War Veterans Graves and History Pages http://enfieldwargraves.smugmug.com My companion book I authored http://www.blurb.com/books/1137672
|
|
#4
04-18-2010, 03:56 PM
|
||||
|
||||
|
New surface for the top of the dash...the old one was in OK shape ...except for the holes left by previously mounted electronics...
 A new skin of Starboard and she looks like new...adding a lip to the side so stuff won't slide off while I'm about whackin this stuff...  The compass will secure the center and a few screws around the edge and POOPH!!...new console top...ain't this FUN!!... Cvencer...went w/a 6" set-back jack-plate...worked OK on a trial run, but have raised the motor a notch since, so the next run will be a trial too!!...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
Last edited by reelapeelin; 04-18-2010 at 04:10 PM.
|
|
#5
04-19-2010, 07:58 AM
|
||||
|
||||
|
Wow, new dash! Looks Snagg-olicious!!!!
__________________
 1994 Wellcraft V21
|
|
#6
04-20-2010, 09:18 PM
|
||||
|
||||
Quote:
LOL!!! Looks great Reel!
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
