New Dash For The 21
 

I didn't trouble-shoot any of them cause I knew all the gauges were gonna go...I wanted to have the sonar built in so a new dash was required...last night, in the cool of the evening, I tore out the old...

http://i3.photobucket.com/albums/y90.../95V-21011.jpg

Labeled all as I went thru...today decided on the new layout and went at it...first a template to make sure it would all work...

http://i3.photobucket.com/albums/y90.../95V-21017.jpg

Anything white showing thru the red got cut away...fit all the stuff into the template...

http://i3.photobucket.com/albums/y90.../95V-21015.jpg

It all lined up pretty good, so went ahead and whacked a new one outta 1/4" Starboard..had to remove the wheel to saw the dash, so went back w/my old one from the '74...

http://i3.photobucket.com/albums/y90.../95V-21022.jpg

http://i3.photobucket.com/albums/y90.../95V-21023.jpg

Still gotta get behind there and rewire everything...hopefully tomorrow, but things are still movin along...oh and to catch up on some earlier business, had the shaft on the Minn Kota lengthened and got it mounted the other day...preceded by cutting away the center section of the bow-rail...hate doin that, but just can figure a better solution...

http://i3.photobucket.com/albums/y90.../95V-21008.jpg

Somebody posted some pics after shortening the legs on their bow-rail...I thought it looked GREAT and will do same later, but right now, I gettin what's GOTTA be done to GO FISHIN!!...:sun:

Not much left to do is there? .....gettin' er done!!!

reel, looks great, that's my next project. my gps/sounder is on the shelf on the other side of the cabin door. what did you make the template out of?

Yeah...everytime I start to think that, a LIST as long as my arm jumps out...the sonar still needs GPS antenna installed/wired, temp sensor installed/wired and transducer installed/wired...hydraulic hoses to trim-tabs installed (pump's in) and wires pulled to dash, nav lights...and on and on...whew!!...it'll get done...I gotta FISH :party:

Hey Phat...template is cardboard from one of the kid's old high-school science projects :zip:

You do good work my friend, very nice:clap:

Glad you like...now get yer arse-end on down here...we got into some stripes the other day...bring your bow...after we fish, you and Mike can shoot his targets by the shore of beautiful Lake Hartwell :sun:

Beautiful job. I like the layout. Well Done!!:clap:

Congrats looking good! :clap:

BS and I started the rewire on the Ox the other day, I have pic's and will load later

Reel-
I probably missed it on one of the threads but what did you end up doing about the shaft length on the Honda? I remember you weren't sure if you were going to jack plate it or try and extend the one you had.

-Svence

You be pimpin' out da dash wit da starboard stuff..............
Nice job looks great.............