|
|
|
|
#1
|
|||
|
|||
Normaly the vent port on the tank should be in the front section, if that is the case with yours, all you have to do is relocate the vent fitting more forward. Where is the tank fill fitting?
__________________
GIORGOS/TAKE A KID FISHING 1981 FORMULA F-233 UNDER COMPLETE RESTORATION. 2008 GRADY 336 T/350'S 
|
|
#3
03-29-2010, 10:05 PM
|
||||
|
||||
|
and there is no vent port in front of the tank. Drilling and taping a new hole is not going to be easy, CB said to try to find a Y connector for the fill??
I was thinking if I removed the fill hose near the gas cap and drilled a hole into it and put a smaller hose in it the fill would work as a fill and a vent?
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#4
03-29-2010, 10:05 PM
|
|||
|
|||
|
That doesn't sound right. Maybe they used the second pick up(some times tanks have a second pick up or return for diesel) instead of the original vent pick up. Check to see if you have a fitting or a pluged hole next to the tank fill (on the tank), if you do, that should of been the vent.
__________________
GIORGOS/TAKE A KID FISHING 1981 FORMULA F-233 UNDER COMPLETE RESTORATION. 2008 GRADY 336 T/350'S
|
|
#6
03-29-2010, 10:11 PM
|
|||
|
|||
|
No, tank fill is forward, so is correct. If tank fill is located in the middle, then yes, is installed backwards.
__________________
GIORGOS/TAKE A KID FISHING 1981 FORMULA F-233 UNDER COMPLETE RESTORATION. 2008 GRADY 336 T/350'S
|
|
#8
03-29-2010, 11:08 PM
|
|||
|
|||
|
I like the idea of a Y connected to the filler hose, If not drilling is plan B, Just a FYI my filler and vent is towards the transom on my Boat I flip the tank around to make it work, I have no vent issues, my plan was to drill a new vent if I needed to.
.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
