|
|
|
|
#1
|
||||
|
||||
Chum,
Thanks for finding that photo. I'm pretty sure that is the same seat that I have from what I can see of the chrome frame in the photo. Our boat might have came with that seat of course that catalog is an 1989 and our boat is a 1987. Hmmmmmmmmm
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;) 
|
|
#3
12-14-2009, 06:45 PM
|
||||
|
||||
|
Thanks again to all for a warm welcome.
I was messing around on the boat this afternoon but forgot to take a photo of those mounting pins that hold that bench seat in place. I will do that tomorrow after. I almost got all the trim woodwork off the boat. I will then spend sometime refinishing the wood.
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;)
|
|
#4
12-14-2009, 09:12 PM
|
|||
|
|||
|
INA40, this may just spark a debate. I recommend you clean your teak up well, including sanding, then hit it with 3-4 coats of Sikkens Cetol Marine Finish. No, this is not SPAM. This stuff just works very well. It used to suffer from a bit of an orangish (is that a word?) cast, but the modern product and the variations thereof look very nice. Cetol is very durable. I would avoid the gloss finish, but the traditional, satin and natural teak finishes are very nice. Another nice thing about it is that once a year, you can lightly sand any nicks or cuts, Cetol it up, and you are good to go for the year. I have found this stuff works much longer than teak oil or varnish, at least for a northern boat which spends 1/2 of the year (at least) under cover.
|
|
#5
12-15-2009, 07:09 PM
|
||||
|
||||
|
Nipper,
Thanks for the suggestion on the Sikken. I have a good bit of Helmsmen left over from doing the Whaler wood work last summer. However it would probably a better idea to use something of better quality. I took a few photos of the mounting pins that hold the bench seat to the floor.  The pins have a button to release the ball bearings the hold the pins into the floor mounts.  The pins would slide through the frame of the seat and into the floor mount. 
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;)
|
|
#7
12-16-2009, 07:23 AM
|
||||
|
||||
|
Hate to bring up a negative, but it's a reality around here...how did Wellcraft keep water from entering the center hole of the bracket?...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
