this years winter project

[RWilson2526]

Pete just thinking....As far as I know the tank I have in there is good albeit original (no idea for sure until I yank it out) I am only replacing it because I got a 3 year old custom made one out of an 86 V-20 for pretty much nothing and figured as long as I was doing the hatch I'd do the tank....the old one is yours if you want it.

Not sure if its worth the trouble to install a 20+ year old tank but just thought I'd throw it out there.

[NOTHING ELSE MATTERS]

O.K, got the info from my tank.
Is made by INCA molded products in Nashville TN
Phone# 615.350.7290 and is 60 gallons.

[NOTHING ELSE MATTERS]

http://www.incaproducts.com/site/default.aspx

here is their web site.

[captpete13]

Thanks for the info guys. N.E.M. that tank looks shorter and wider than my tank. What are the dimensions? Reel.. thanks. We are jamming at work right now and now the boss is saying we will be working till the 23rd and we will also get paid for the week between Christmas and NewYear. So I will only be laid off for about two weeks. That makes me feel a little better. Rob your the man! I will absolutly take that tank. If you need a hand getting it out let me know. You can use my shop.

[RWilson2526]

Originally Posted by captpete13

Thanks for the info guys. N.E.M. that tank looks shorter and wider than my tank. What are the dimensions? Reel.. thanks. We are jamming at work right now and now the boss is saying we will be working till the 23rd and we will also get paid for the week between Christmas and NewYear. So I will only be laid off for about two weeks. That makes me feel a little better. Rob your the man! I will absolutly take that tank. If you need a hand getting it out let me know. You can use my shop.

Oh now we're talking...the only reason I am even starting to procrastinate is because I dont want to freeze my *** off.....I can see that working out...I'll drag the boat down there, give me a hand pulling it out (which seems to be the hard part) and leave the tank there. Deal....this will stop me from putting it off too until spring.

I need to get whats left of the gas out, I'll try to do it this week and then we can set something up...

[captpete13]

not a problem. By later this week I should have a better idea when we are shutting down. Anytime after that is fine with me.

[Geekie1]

The standard 60 gallon tank in a 1984 V20 cuddy cabin outboard model has exact dimensions as follows:

Length = 44.75"
Width = 31"
Depth in center of tank (Belly tank) = 11.5"
Depth at sides of tank = 7.25"
Angle of belly tank bottom = 22.684 Degrees (same angle as V20 dead rise)
Bottom of belly tank is flat and the tanks flat bottom is 10.75 wide.

This tank is also used in 1985 V20 center console fisherman.

I have a scale Wellcraft drawing of this tank with all of the dimensions and location of the fill points vent, and sending unit and ground. When I figure out how to get the drawing into my computer I will post it!

Geek

[NOTHING ELSE MATTERS]

Mine tank is 31x32 . Is the FO6008 model from inca products.

[msbhammer]

Looks good, dont stop.

[Airslot]

Wazzup Hammer...