Gel coat

[NOTHING ELSE MATTERS]

I was thinking of Awlgrip but as a consumer, i don't think i can buy it. I used in the pass the two part Interlux(perfection) with good results. It would be O.K for the electronics box, but for the pulpit i want to make, gelcoat i think is tougher. What you guys think ?

[spareparts]

west marine retails awlgrip now. The price of material runs about the same, but you end up with less labor in the paint by not having to block out the finish, and you don't run the risk of sanding thru and having to start all over again.