|
|
#6
09-16-2009, 08:24 AM
|
||||
|
||||
Agreed, definetly do the large stainless washers at least on the inside. Any stock you can up and drill yourself(stainless or aluminum) would be best with the washers. Also fill the gap with your preference and bolt the sides also.
the forces on that transom especially under way with that 500lb engine bouncing in the water is tremendous and I think you may be underestimating it.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode