|
|
#12
09-16-2007, 12:27 AM
|
||||
|
||||
Re: Just a peek
Quote:
I's thinkin' the same about a poured concrete BLOCK... but then I got to thinkin' about deployin' that SOB and tsubaki's on the right track fo sho !! ;) ...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#14
09-16-2007, 01:01 AM
|
||||
|
||||
|
Re: Just a peek
Quote:
Ya think ??? ...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha
|
|
#15
09-17-2007, 09:45 PM
|
||||
|
||||
|
Re: Just a peek
WOW!!! Thats a litle more complex then my boiler pan mooring ;D
Howare you planning on rigging that? Engine Block is the old faithfull around here for the Pirate (un regulated) moorings ;)
__________________
|
|
#16
09-17-2007, 10:14 PM
|
||||
|
||||
|
Re: Just a peek
The hole where the anchor is going is about 10ft deep at low tide, the location for the boat between the anchor and the dock is about 3-5'deep. The distance between the them is about 50' from the anchor to the bouy and 50' to the dock. Some where in between is where the boat will be.
Now we also got a 10' fluctuation between the tides to contend with so this will take some trial and error. There will be a line tied to the dock from all this. The reason I can't simply tie off to the is dock is at low tide for about 5' away from it has no water and the boat will list too badly to one side.
__________________
 '75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
