Help Removing Lower Unit

[Airslot]

If you got it to drop an 1/8, try gently driving a couple wedges in the gap.

[phatdaddy]

hope the driveshaft is not froze to the crank

[macojoe]

hope the driveshaft is not froze to the crank

tHATS WHAT happened to my Rude! BS had it hanging upside down for days and itnever came apart! Sold it to someone just like that.

[cterrebonne]

do you have a gap all the way around the lower unit and mid section?

[HookedOnMarsh]

Yes CTerrebonne, I do have a very small gap all the way around. I can see through the gap anough to make out the waterpump housing and I can make out the shiftshaft rod. I still would like to think that it's not the driveshaft, that it's that front stud that isn't moving at all.
I almost thought about taking a sawzall blade in the gap and cutting off the stud, but I know that's going to be asking for trouble, because the rear bolt from under the anode tab was missing when I took off the anode. Just a straight hole all the way. And I'm positive that there is not a bolt still in it because I can seperate them enough to see the anode bolt and there is nothting else in the way.

[HookedOnMarsh]

Well I put it back in the water today and it ran OK, but the temp gauge has went from running at 1/4 gauge to 1/2 gauge on plane. It did have a full tank of gas and drinks and 4 people onboard with some decent swells out there. Not wanting to melt the powerhead, I brough it back in. Telltale is sputtering a little so I know it's time to replace that pump.
Going to give it another go today with prybars. What would happen if I tied the lower unit to a post and pulled lightly with the truck?
Will a shop touch a job like this and if they do, how much would it cost to have it done?

[macojoe]

Don't go pulling the thing with your truck!!! That thing needs to drop down kind of even or you are going to bend or worse break things!!!!

You need to find out what it is hanging on, I am sure the shaft is rusted into the bottom of the power head and it might mean taking the motor off and hanging it upside down or on a angle to get some oil in there to try to loosen it up.
Try a wedge front and rear and hit each a little at a time. I had one I had to do that way once and it worked, but it is scary thinking you might break something.

Any way when you get it off put some never seize on the end of the shaft to stop this from happening again.