|
|
|
|
#1
|
|||
|
|||
that stud sounds like it is hanging up. you have six nuts removed right? only 4 if its a 20" with the last two loose? you might have to beat on that stud in the front.
|
|
#2
06-16-2009, 12:41 AM
|
|||
|
|||
|
Thank you CTerrebonne for the fast response. I got 4 of them out and the 2 side ones loose. The shiftshaft doesn't have to be turned any certain way does it? I will proceed to get my mini-maul and give it a harder whack in the morning then.
|
|
#3
06-16-2009, 08:07 AM
|
|||
|
|||
|
it shouldnt it should just slide out.
|
|
#4
06-16-2009, 06:58 PM
|
|||
|
|||
 Man, I tried. I guess I just got bad luck. I beat it this morning before I went to work. Not one budge. I soaked it down with more WD40 and came back this evening and beat on it some more with my mini maul. I've hit hard enough to mangle the very top of the stud. I've tried lightly prying the lower unit from the tailshaft, but I'm afraid something will break. I see no way to get the stupid thing off. Anything else I should try to do before I just put it back together, cut off the top 1/4 of the front stud and bolt it down and let it rip until the pump does go out?
|
|
#5
06-16-2009, 08:37 PM
|
||||
|
||||
|
Quote:
__________________
1986 V-20 1986 Yamaha 150 HP
|
|
#6
06-16-2009, 08:50 PM
|
||||
|
||||
|
If you got it to drop an 1/8, try gently driving a couple wedges in the gap.
__________________
Airslot Airslot's V-20 Gallery
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
