|
|
|
|
#1
|
|||
|
|||
No, I didnt print your instructions so I went by the manual I had handy that said blue/tan lead wire. Sorry I'll recheck it. I did see those black/tan wires coming out of the port side. You think I should disconnect both blue/tan and black/tan maybe?
__________________
1984 V20 Steplift Cuddy Seadrive converted to bracket 1992 175EFI Mariner 
|
|
#2
03-26-2009, 08:55 PM
|
||||
|
||||
|
The blue and the tan wires in the TPS are the ones you measure to get your reading. The port side sensor should have 2 leads coming out that are tan with a black stripe on them. Disconnect both of them and re-check your adjustment.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
04-06-2009, 07:44 PM
|
|||
|
|||
|
Thanks again THEFERMANATOR, Got the correct leads disconnected this time and I got it set to .25 on the money. The wide open throttle is 6.25 definetly runs better at this setting.
__________________
1984 V20 Steplift Cuddy Seadrive converted to bracket 1992 175EFI Mariner
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
