Transom.....son of a b!&*(

[RWilson2526]

[quote=nymack66;136768]
An old timer did a test on my Transom before and after my stress testing and told me there is zero flex on my transom.
quote]

What's the procedure for testing for flex? I have pushed and pulled on mine and all seems stiff but I always wondered if I needed to do a better inspection....(although I'm a little scared!!!)

[Chomper]

I just got done removing the wood from mine and as mauryc said it is brutal, but it can be done. I would say I have gotten all the wood I can out probably around 90 to 95 percent and the whole bottom is down to the fiberglass all the way across. I do have some very thin wood left on the sides in places but it just won't come off so it is staying. I was a bit conservative with the chainsaw and chiseled most of the bottom out which seemed like it took forever but I got there. Keep chipping away.

[nymack66]

Originally Posted by Chomper

I just got done removing the wood from mine and as mauryc said it is brutal, but it can be done. I would say I have gotten all the wood I can out probably around 90 to 95 percent and the whole bottom is down to the fiberglass all the way across. I do have some very thin wood left on the sides in places but it just won't come off so it is staying. I was a bit conservative with the chainsaw and chiseled most of the bottom out which seemed like it took forever but I got there. Keep chipping away.

For this stage use a sharp wood chisel and attach duct tape it to a pipe this works , Also it did rain and fill up my project when I was working on it low and behold it seem a lot easer the next weekend when I finished it.
The wood came off the skin with no effort !

[mauryc]

Shane, Where are the pics?

[nymack66]

[QUOTE=RWilson2526;136791]

Originally Posted by nymack66

An old timer did a test on my Transom before and after my stress testing and told me there is zero flex on my transom.
quote]

What's the procedure for testing for flex? I have pushed and pulled on mine and all seems stiff but I always wondered if I needed to do a better inspection....(although I'm a little scared!!!)

First I tilt the engine all the way up and lock it in place, with me pulling on the prop he was visually check both the outside and inside for movements or flex. Note (I did this before the new transom) and yes it did flex !
On the lake he use tow pieces of 2 x4 and made a mark on the floor of the Boat , I did some 360 and WOT etc, all seems well and no flex.