|
|
|
|
#1
|
|||
|
|||
Is it possible the float levels wee set wrong during the carbs rebuild? Allowing to much gas into the cylyinders and loading the engine down at idle/start up. I suspect if this was the case you would see gas coming out of the carbs at low speed as well.
Kamikaze
__________________
 74 V20 CC with a 150 Johnson (Gone but not forgotten) 89 V20 Cutty with a Tower (Build in process) 
|
|
#2
08-06-2008, 06:36 PM
|
|||
|
|||
|
The floats were right on the money so I didn't make any adjustments. I went and restarted the motor without lifting up the high speed idle lever and there was very little smoke. I'll let it sit overnight and try again tomorrow. I plan to take it out on friday and see what happens after running for a while.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
