Fuel fill length

[willy]

And do your vent line and hoses from tank to filter and engine at the same time, if one was going they will all need to be done.

[Stillrunning]

While your replacing all you gas lines replace any clamps that look bad and use double clamps on all connections.

[regidog]

You may want to leave that hose in place and use it to pull the new one through. To get a measurement disconnect the line at the tank and run a piece of flexible material through till it shows up at the other end than mark the line and pull it out.

[willy]

you are actually better off pulling the original hose out and pulling a pull line or two with it. it is hard to measure with some diffrent material.

[phatdaddy]

DB, i was cleaning out my shed & found my old one. i have a 83 cuddy with the tank located in the rear end of the deck(right against the splashwell). mine was 6.5 ft. i probaly bought a 7 ft piece..

[dbetterred]

Thanks for the length. I came up with about seven feet. I'm slightly rerouting the hose so I just ordered an eight foot piece. It should be here this week.