|
|
|
|
#1
|
||||
|
||||
Just wait till you get that one out before buying! This way you get it right, its not like you can do anything till you get that one out anyway.
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#3
07-30-2008, 08:28 PM
|
||||
|
||||
|
And do your vent line and hoses from tank to filter and engine at the same time, if one was going they will all need to be done.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW
|
|
#4
07-31-2008, 09:54 AM
|
|||
|
|||
|
While your replacing all you gas lines replace any clamps that look bad and use double clamps on all connections.
|
|
#5
07-31-2008, 12:12 PM
|
|||
|
|||
|
You may want to leave that hose in place and use it to pull the new one through. To get a measurement disconnect the line at the tank and run a piece of flexible material through till it shows up at the other end than mark the line and pull it out.
|
|
#6
07-31-2008, 01:03 PM
|
||||
|
||||
|
you are actually better off pulling the original hose out and pulling a pull line or two with it. it is hard to measure with some diffrent material.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
