Re: Transom Cap wont Fit
Ok, I finally made the transom cp fit on. Adding the extra ply didnt work. Just pushed everything forward, causing more cutting. The reason the cap wouldnt go on right is that when I rebuilt the transom, so how it got racked at the outside corners. wich is strange because the is the strongest point...at the corners. I was 3/8 out on both corners. Causing me to try and twist the cap on. So it was either scribe in the transom or knotch the cap. So I knotched the cap, cutting off a bit of the rear where it comes over the side. Will need to do a little more glass work, but the cap now fits on. ;D
__________________
|
Hybrid Mode
