Running Lights Wiring Question

[tsubaki]

Originally Posted by greateastern

I have grey and black wires, the greys go to the switch the blacks I will trace out after work. When I put the meter to the 12v dc wires the meter reads -12.5v dc with the red meter lead on grey and the black meter lead on black. then I change it around and I read 12.5v dc no more - so i figured the grey wire is the ground wire, neg, to the meter. Does that make sense?

Yes that should be the case, and is this with the light switch on and both bulbs burning?
There are a lot of variables, if someone derived the negetive from a dashlight panel and a wire broke or bulb blew, this could create a whole number of funny readings.
First try to localise the ground from the lights to their source, as to where they are connected.

You wouldn't believe the mess created by the "mechanics" on a brand new boat that my neighbor bought.
Most all of this is simple but when you get to thinking too hard it makes a bigger mess.
Rewiring does give a lot of piece of mind.

[tsubaki]

Are these the old pull type switches, toggle type or the rocker switches with an indicator light?
Only real difference is the switch having a ground to them.

[macojoe]

Easy! Just rip the thing out of there, and run a new one!! Do I have to think of everything??

[tsubaki]

BEST ROUTE and you can do it a little at the time.

[cterrebonne]

if you still arent getting 12v and dont want to rip all of the wires out and start from scratch replace the blade connector on the switch and the connections at the lights. 99% of the time corrosion with cause the voltage drop. also you messed up when cutting the black loop you need that to be connected it gives power to each bank of the 6 way switch. do this. connect the middle wire on one side directly to the wire that is suppose to bring voltage to the light and test in the front. if you have 12v to the front then its a bad switch or bulb. if no 12v then you have a ground issue.

[greateastern]

OK, Riddle solved. The black wire going to bow light was broken inside the jackect. Now all I have to do is figure out the factory wiring (because I cut the looped black wire under the stern light) The switch is a 4 blade with power coming off the fuses above it. on /off/ on toggle. only two wires hooked up to it the fuse wire and a feed going to the stern light. If someone can draw a simple wire digram for Running lights I will just rewire the lights ( I would like running light (All), and anchcor light(Stern)
P.S. Bought new led bow light and stern light might as well do it right.

Thanks To All.

[csvencer]

I second redoing all the wiring, its only a matter of time one of the other wires loses connection. Grab some duplex wire (two wires, one sheath) and pull it through with the old one. Then you might want to redo the switch with a Double Pole Double Throw, simplest way to wire nav/anchor with one switch.

-Svence