Anti slip paint question...

[Stillrunning]

I used Berh garage floor paint from Home Depot with a little non slipp mixed in and it has held up very well. I just hit the floor with a sander and then wiped it down with paint thinner. I only mixed about 3/4 with the anti slip which I used on the flooring. I then painted the inside of the floors storage boxes with the paint without the anti-slip. The only thing you need to be careful of is mixing in too much anti-slip. Add a little at a time and test it on a peice of wood. It does not take very much and if you do as I did the first time it was like sand paper. I then had to sand and do the jod agian. It only cost about $35.00 and if it does chip I had a little extra for a quick touch up.

[tsubaki]

Sold at Bass Pro.
Moderate color range.

[Stillrunning]

Originally Posted by tsubaki

Sold at Bass Pro.
Moderate color range.

This stuff says you could spray it but you would think that the anti slip stuff would clog up the gun.

[tsubaki]

We discussed that while rolling it.
Best I remember, the type of gun you use to splatter a ceiling with is the same one used with the nozzle turned down.
There is a roller designed for this paint type use but it appears any nappy (headed) roller will do the job.

[drj]

I wouldnt use any of my good guns but i bet it would go on very nicely and evenly with one of those cheap Harbor freight ones. I am going to do it to my V soon. Anyone know how much to use for a center console?

[Stillrunning]

Originally Posted by drj

I wouldnt use any of my good guns but i bet it would go on very nicely and evenly with one of those cheap Harbor freight ones. I am going to do it to my V soon. Anyone know how much to use for a center console?

I used the Home Depot garage floor pain and did my entire floor and storage boxes in the floor using a gallon and had some left over for touch up.