|
|
|
|
#1
|
|||
|
|||
previous owner.
Am i right that my engine stuck at full tilt is normal after filling with fluid until i loosen the pressure release valve? i'm assuming once the pressure is released, the engine lowered, all i should have to do is engage the tilt motor and it should work. not ready to give up DIY yet. 
|
|
#2
03-22-2008, 08:07 PM
|
||||
|
||||
|
If the pressure release scre is closed, the rams should stay in place unless you either release the pressure or engage the trim motor. Sounds to me like you need to block it all the way up and try and get the trim motor off and see if the plastic drive sleeve is there. I know mine has a sleeve in it that was broken on my old trim unit.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
