![]() |
|
|
|
#1
|
|||
|
|||
|
Thanks for the replies, good thing i asked....
Ok i will disconnect the VRO. I did the transom test thoroughly and it is rock solid...very...will fix cap. The motor powerhead was rebuilt by the mechanic who owned it... i don't think it was run much since the rebuild a couple years ago. The boat was used as a shrimp boat and has a lot of gouges and scrapes. The deck is soft in front of the console but not bad. That will be a project for later. my goal is to get it in the water first..make it pretty after that. I did find the correct wiring harness with the red plug and an OMC ignition switch and i got it mostly wired...just need to get a battery and hook that up and test and crank. I previously rebuilt a delapidated 1973 Winner with 305 OMC inboard..so i know what to expect and i like that sort of pain. It came out beautiful. The trailor is bad off. First item i bought was a boat cover. thanks for being there no doubt i will have some questions in the next few days. |
|
#2
|
|||
|
|||
|
i called the previous owner.
He ran all the fuel out of the carb before storing the engine. Does anyone have a wiring diagram for the fuel tank? Is there a way to verify if it is clean or dirty inside? |
|
#3
|
||||
|
||||
|
Just start her up!! New gas, the new gas will clean it right up. Don't go looking for trouble!
__________________
1986 V20 ![]() Old Fishermen never die, we just SMELL that way!! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|