Rod holder ?

[SkunkBoat]

before you go cutting holes...

The other problem you will encounter is that you cannot angle them out in a normal trolling spread. The gunnel is not wide enough to mount them outward at 45 and 90 degrees. 6 rods all pointed straight back make a tight spread!

I have 3 in each gunnel...i'll try & find a picture...

forward of the rod box is a 0 degree (straight up,this is for drifting not trolling), aft of the rod box is a 30* straight back and in the far stern I have a 30degree angled out 90 degrees. There is room back there but you have to remove the "bait bins" and use a special rod holder from GEM that doesnt have mounting screws