Quote:
Originally Posted by SkunkBoat
sorry to see the problem with the transom. I was worried when I first saw your pic of the outside skin cut off. Not the best way to do it. People think its faster and easier than cutting the cap and going from the inside but then its all on you to shape it.
Question. Could it be that the holes are drilled in the wrong place or angled incorrectly? If you remove the bottom bolts and snug the top, can it sit flush?
Second.
Rather than shave it, consider adding to it to make a flat surface. Way easier. Use some EPOXY hard filler.
|
No. it's definitely bowed. I put a straight edge along the transom and it teeter-totters like a playground toy. After thinking about it I agree adding material would be better than shaving it down. Guess I'll pull the motor off yet again and see what I can do with it. That's really the least of my worries right now as I gotta reconstruct the splashwell as well. He's got all sorts of 2x4's everywhere I guess bracing things up. Seemed a bit excessive to me. And as you said it had to be shaped back and it was not shaped back at all the way it was. Everything is kind of radiused now and looks terrible. I'm not sure at all how I'm going to get a somewhat sharp edge there without it being weak and breaking off easily.
Quote:
Originally Posted by Destroyer
One picture is worth a thousand words, etc. I'm not endorsing this particular brand or dealer, but this is what a thread file looks like, as shown in the picture. They (the files) come in several different types, to cover all the different thread sizes that are on the market.
http://www.ebay.com/itm/8-IN-1-THREA...656516&vxp=mtr |
I have seen those before. My dad alsways had a few in his toolbox but I never knew what they were. I'm going to get info on the threads and order one. Worth a shot.
11-14-2016, 07:44 PM
Threaded Mode