Quote:
Originally Posted by tartuffe
Kracker, after dozens of opinions,, I would like yours, what did you end up using to glue your stringers in?
I was thinking of using a bunch of pl glue and fileting the edge with the excess, then coming back with 1708 oooorrr rubber 1/8" spacers and thickened resin to bed it and fillet.
It looked like you left the bottom 1" of your original stringers glass to hold the new in place, is that right? If so, did you leave the entire channel or just pieces to hold the stringer in place?
|
Numerous guys I talked to in the begining used pl. I was gonna go that route simply because I didn't know much about additives and thickners. After doing more studying and research I learned to use thickeners. I would cabosil your resin and glue it like that,then make your fillets with the same mix then layup your glass. My stringers are bullet proof using that method. Your pl wount do ya much good as fillets in my opinion. I'm am no professional either
03-07-2012, 08:53 AM
Threaded Mode