Spraying ether to start - Wellcraft V20 Community

		Wellcraft V20 Community > Wellcraft V-20 Forums > Performance
Spraying ether to start

08-18-2011, 05:05 PM

Joker2

Senior Member

Join Date: May 2009

Location: Long Island, NY

Posts: 269

went down today using my Seloc manual disconnected the Black Yellow single pin plug at the power pack, engine started right up and ran fine, I couldn't stop it unless I plugged it back in. Unless I am reading the book wrong ( which very well could be ) this means either my Emergency kill switch or my ignition switch is bad correct? Can anyone verify this for me?

__________________
Tight Lines !!

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -5. The time now is 12:18 PM.