I have a Johnson and I have bowl drain screws on each bowl. Looking at you middle picture it looks like you have the same thing but on the bottom of each bowl (notice the brass screw on the bottom of the bowl). Do you have a seperator on the boat an if so you may want to switch the filter to one that has the plastic bowl on the bottom that you can drain. I know with E10 gas there are moister issues but if you getting that much water in you gas all the time its coming from some where. Where is your vent hose located and could water be splashing up and into the vent? Mine is turned slightly back to prevent that from happening. If you mix you oil and have a carbed motor its important to keep the jets clean as a cyl running to lean can burn up that cyl. I read somewhere that is the cause for like 90% of carbed motors burning up a cyl.
|
04-07-2009, 08:04 AM
Threaded Mode