Question for Willy

[kamikaze]

Willy:

Thanks for the info. I too install initally at 3" per D&D Marine install instructions and found it to hig, so I couldn't image 6 inches was any fun. I raised the bracket 3 1/2 inches on the transom, added a 5 inch extension to the motor (previously a 20" shaft) and now the motor only sits a little over and inch and a half above the keel line. However, at speed I can ventalate the prop when I have a half tank of fuel for less. I can lower the motor another 1/2" or so since it's currently slightly evelated on the bracket, but not sure that's going to due much good.

I agree with your water line comment and think much of my problem is that the fuel tank is to far aft ( to the point that water will flow in through the scuppers if your standing in the stern) and the boat raises in water as fuel is burned off, basic lifting the engine and ventualting the prop when on plane.

Thanks Again

Kamikaze