Johnson Tilt & Trim - Wellcraft V20 Community

		Wellcraft V20 Community > Wellcraft V-20 Forums > Repairs
Johnson Tilt & Trim

Thread Tools

Display Modes

10-07-2007, 10:04 PM

coork

Junior Member

Join Date: Oct 2006

Location:

Posts: 16

Johnson Tilt & Trim

Need to replace seal in center tilt cylinder on 200 HP 1990 Johnson. How in the heck do you drive the tilt cylinder pin out? I believe I have reached a neutral position so shaft is not loaded but the pin will not budge. I would hate to pull motor from the boat.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

All times are GMT -5. The time now is 12:52 AM.