black covering on 89 v20 console???

[reelapeelin]

Originally Posted by Skools Out

why don't you remove it sand then roll on some top side paint with a little non-skid, then never fear it peeling again plus easy to touch up later.

That'd be a great way to go...another way would be 1/4" Starboard...remove all the existing paper and entire dash...you might wanna consider all new gauges, too...mine looked about like yours when I first drug her home back in 1999...the old sonar unit shown here has been replaced, but this approach has worked well for long time...



...just remove the existing dash and cut out the fiberglass behind it leaving a 3/4" lip around the outter edge to fasten new w/ #8 Stainless screws...routing the edges give it a nice finished look...a piece cut and routed to fit the top of the console would look great, too...use white up there as any other color will absorb too much heat...

Good luck w/whatever approach you take and keep us posted...