|
|
#1
|
||||
|
||||
Seat Boxes
Got a local guy that says he can make seat boxes for our V20's soem one with a v21 take some measurements for me. Height, width, length. How many of ya'll would be willing to buy a new seat box. If this works out, I may be able to get him to make some other small items
|
|
#2
05-21-2016, 09:04 AM
|
|||
|
|||
|
I would be interested depending on the cost. Did he mention that? Have you seen anything that he has done ? Thanks.
__________________
An adventure is a disaster that fails to kill you!! 1987 V20 Cuddy 175 Yamaha SOLD 1996 V21 Cuddy 200 OceanRunner SOLD 1994 V21 Cuddy 150 Mercury SOLD
|
|
#3
05-21-2016, 09:14 AM
|
|||
|
|||
|
mawshj
I will be looking to replace my lounge passenger seat this summer. V20 cuddie 1983. several (maybe 2 I have found) make replacements. (high storage base with snap close flap)(larger then most seat dimensions)(pull out to lounge position)(rot proof frame). I am not sure what your seat box is but I would certainly take a look at it
|
|
#4
05-21-2016, 01:48 PM
|
||||
|
||||
|
is he making the seat insert in the center console?
__________________
1985 Wellcraft V-20 2000 Yamaha 150hp OX66 FI 1988 NorthCoast 24 twin screw 5.7 1988 Shamrock GS31 twin 350hp 454 2007 Triton 2690 2x200 Suzuki 4 strokes
|
|
#5
05-22-2016, 07:41 AM
|
||||
|
||||
|
The guy who may be building these is the guy whos making the small skiffs I posted up a while back. Were trying to get some measurements to see if we could be able to adapt an existing mold to work. Don;t have a price yet, I'll be the test subject on this one
|
|
#6
05-22-2016, 09:31 PM
|
||||
|
||||
|
Just measured it.
39" long x roughly 21" wide x 12" tall. I say roughly cause I measured the front at 21 1/4 and the back was like 20 3/4. I think it is a bit funny they didn't just go 40" long. Could've used that extra inch a time or two on the fish box side. 
__________________
 1994 Wellcraft V21
|
|
#7
05-22-2016, 10:28 PM
|
||||
|
||||
|
thanks
|
|
#8
05-23-2016, 07:37 PM
|
|||
|
|||
|
Quote:
|
|
#10
06-01-2016, 05:29 PM
|
||||
|
||||
|
working on the plug. Estimated cost is going to be around $250-$300 per box. You will have to trim it to fit the angle of the cockpit floor. It will be square(measurement wise) so you can use it on either side or mount it in the center behind a console. It will have a wood backed top for reinforcment. When we get a prototype done, i'll post up some pictures
|
 |
|
|
Linear Mode
