bow rail

Well, describe what you want and I'll see if I can't help ya out. I bent tubing ranging from 1/2" - 6" for years. Know any electricians?

[rhahn427]

I was thinking that I would buy the tubing and the connectors to use the same mounts as the existing rail to duplicate the existing rail but without the front section.

To do this I need to duplicate the curvature of the existing rail. Everything would be exactly the same except the rail would end about an inch past the last mount on each side and capped.

To do this the bending would have to be done at the boat or I could take off the rail and the bending done somewhere else.

Thanks

Rick

[macojoe]

Hdere is what you need!! This is CB's boat when he had it, I had a guy here that was supose to sell me his when he took them off, He contacted me a few times and disapeared??

But here is wellcraft Oringal rails off a CC

[rhahn427]

Oh Yeah !!!!! ...............

.... THAT"S EXACTLY what I want !!!!!


EXACTLY ........

[rhahn427]

Originally Posted by chesapeake_dreamer

Well, describe what you want and I'll see if I can't help ya out. I bent tubing ranging from 1/2" - 6" for years. Know any electricians?

Hey guy .......... could use your help ....... I'd like to get them bent just like the ones in Macoejoe's post ....... are you around the Baltimore area?

Thanks

Rick

[rhahn427]

btt