|
|
#21
|
|||
|
|||
Re: Floor Drain Elbow Broke (@#$%^&)
The V20 deck drain is a design problem. Mine were not broke but cracked so I sanded them down and ran about a quarter inch band of marine tex around the cracks and put them back in. I dont know if you can find the original drains anywhere. Frank
|
|
#22
05-31-2007, 08:43 AM
|
|||
|
|||
|
Re: Floor Drain Elbow Broke (@#$%^&)
Wondering if Tuna is reading this thread. His scuppers were patched over and his deck drains into the bilge area. maybe that isnt a bad idea after all. Just as long you have two hard and fast working bilge pumps. :-/ ???
__________________
|
|
#23
05-31-2007, 09:29 AM
|
||||
|
||||
Re: Floor Drain Elbow Broke (@#$%^&)
 I had to replace mine 3 or 4 years ago, i used a drain for a small sink. i picked these up at a plumbing house they are called bar drains. they are brass and come with a brass stopper. the nipple on the bottom is too long and you have to cut it off so the 90*barb fitting will fit snug against the bottom of the drain. they work great, except they have no screen and stuff will get into them and have to be cleaned.
|
|
#25
05-31-2007, 09:47 AM
|
||||
|
||||
|
Re: Floor Drain Elbow Broke (@#$%^&)
I went to my local plumbing supply house, told the guy what I needed, and he gave me a 1" brass bar stop with an elbow and it works great.
__________________
Airslot Airslot's V-20 Gallery
|
|
#28
05-31-2007, 07:09 PM
|
|||
|
|||
|
Re: Floor Drain Elbow Broke (@#$%^&)
These are some good ideas. I found some bronze fittings online that are flat like the original plastic ones that would let the water drain like the original.
http://www.westmarine.com/webapp/wcs...0001/217/70/11
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke.
|
|
#30
05-31-2007, 09:43 PM
|
|||
|
|||
|
Re: Floor Drain Elbow Broke (@#$%^&)
I looked at those too RB, the only problem is I couldn't find them in the short version and the threads are about 3" long I think, so add that to the elbow and it was too low I think (at least for mine). I considered cutting them off, but then I figured the threads would burr and not screw into the plastic elbow again.
Man one of us should produce these things all over again and make a killing! Frustrating when something is so impossible to find!! ;D ;D
__________________
1994 V-21 Cuddy w/ Yamaha 150
|
 |
|
|
Linear Mode
