|  | 
| 
			 
			#1  
			
			
			
			
			
		 | |||
| 
 | |||
|  fuel/water filter 
			
			I just replaced my fuel/water filter and now the primer bulb will not prime. I replaced the filter without putting any fuel in the filter, should I fill the new filter with fuel to get a prime? Sorry if this is a stupid question but this is all new to me with this fuel/water separator. Thanks 
				__________________ 1976 Wellcraft V-20 Steplift w/1983 175 HP Johnson 1973 Sears 12 ft. V bottom w/1958 3 HP Evinrude "A boat is a hole in the water, surrounded by wood & fiberglass, into which one pours hard earned money into" | 
| 
			 
			#2  
			
			
			
			
			
		 | |||
| 
 | |||
|  fuel/water filter 
			
			I just replaced my fuel/water filter and now the primer bulb will not prime. I replaced the filter without putting any fuel in the filter, should I fill the new filter with fuel to get a prime? Sorry if this is a stupid question but this is all new to me with this fuel/water separator. Thanks 
				__________________ 1976 Wellcraft V-20 Steplift w/1983 175 HP Johnson 1973 Sears 12 ft. V bottom w/1958 3 HP Evinrude "A boat is a hole in the water, surrounded by wood & fiberglass, into which one pours hard earned money into" | 
| 
			 
			#3  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: fuel/water filter 
			
			Shawsee, I believe they recommend you do as you said and fill the the new filter with fuel and then install.  
				__________________ 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ | 
| 
			 
			#4  
			
			
			
			
			
		 | ||||
| 
 | ||||
|  Re: fuel/water filter 
			
			Shawsee, I believe they recommend you do as you said and fill the the new filter with fuel and then install.  
				__________________ 1990 Hydrasports 2000cc Vector with 96 200HP Oceanrunner. Saved by grace alone, through faith alone, in Christ alone http://www.providencerpchurch.com/ | 
| 
			 
			#5  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			I have never filled one before installing.......did you put a little oil on the seal before you installed? It should pump up unless you have an air leak somewhere, or a defective bulb. 
				__________________ *************************************** Stay Safe! Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. | 
| 
			 
			#6  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			I have never filled one before installing.......did you put a little oil on the seal before you installed? It should pump up unless you have an air leak somewhere, or a defective bulb. 
				__________________ *************************************** Stay Safe! Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. | 
| 
			 
			#7  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			I just did one myself... Make sure your bulb is priming foward as it should. 
				__________________ Life is composed of a bunch of little nothings! Sea Ray 19.5 I/O 351 Cleveland - SOLD 1989 V20 CC 1998 150 Ocean Runner - SOLD | 
| 
			 
			#8  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			I just did one myself... Make sure your bulb is priming foward as it should. 
				__________________ Life is composed of a bunch of little nothings! Sea Ray 19.5 I/O 351 Cleveland - SOLD 1989 V20 CC 1998 150 Ocean Runner - SOLD | 
| 
			 
			#9  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			Ok thanks guys. I did put some oil on the rubber seal. I did finally get it primed but it took forever. I now know that next time I will put fuel in the new filter before I even attempt to prime the bulb. Tomorrow is the "maiden voyage" and we are good to go. Thanks again guys for your input & knowledge. This site is truly the best. 
				__________________ 1976 Wellcraft V-20 Steplift w/1983 175 HP Johnson 1973 Sears 12 ft. V bottom w/1958 3 HP Evinrude "A boat is a hole in the water, surrounded by wood & fiberglass, into which one pours hard earned money into" | 
| 
			 
			#10  
			
			
			
			
			
		 | |||
| 
 | |||
|  Re: fuel/water filter 
			
			Ok thanks guys. I did put some oil on the rubber seal. I did finally get it primed but it took forever. I now know that next time I will put fuel in the new filter before I even attempt to prime the bulb. Tomorrow is the "maiden voyage" and we are good to go. Thanks again guys for your input & knowledge. This site is truly the best. 
				__________________ 1976 Wellcraft V-20 Steplift w/1983 175 HP Johnson 1973 Sears 12 ft. V bottom w/1958 3 HP Evinrude "A boat is a hole in the water, surrounded by wood & fiberglass, into which one pours hard earned money into" | 
|  | 
| Thread Tools | |
| Display Modes | |
| 
 | 
 |