Wellcraft V20 Community

Wellcraft V20 Community (https://forums.wmpdevserver1.com/community/index.php)
-   Repairs (https://forums.wmpdevserver1.com/community/forumdisplay.php?f=16)
-   -   fuel/water filter (https://forums.wmpdevserver1.com/community/showthread.php?t=7685)

Shawsee 06-07-2007 10:02 AM

fuel/water filter
 
I just replaced my fuel/water filter and now the primer bulb will not prime. I replaced the filter without putting any fuel in the filter, should I fill the new filter with fuel to get a prime? Sorry if this is a stupid question but this is all new to me with this fuel/water separator.

Thanks

Shawsee 06-07-2007 10:02 AM

fuel/water filter
 
I just replaced my fuel/water filter and now the primer bulb will not prime. I replaced the filter without putting any fuel in the filter, should I fill the new filter with fuel to get a prime? Sorry if this is a stupid question but this is all new to me with this fuel/water separator.

Thanks

Bygracealone 06-07-2007 12:24 PM

Re: fuel/water filter
 
Shawsee, I believe they recommend you do as you said and fill the the new filter with fuel and then install.


Bygracealone 06-07-2007 12:24 PM

Re: fuel/water filter
 
Shawsee, I believe they recommend you do as you said and fill the the new filter with fuel and then install.


randlemanboater 06-07-2007 03:57 PM

Re: fuel/water filter
 
I have never filled one before installing.......did you put a little oil on the seal before you installed?

It should pump up unless you have an air leak somewhere, or a defective bulb.

randlemanboater 06-07-2007 03:57 PM

Re: fuel/water filter
 
I have never filled one before installing.......did you put a little oil on the seal before you installed?

It should pump up unless you have an air leak somewhere, or a defective bulb.

bassarama 06-07-2007 04:07 PM

Re: fuel/water filter
 
I just did one myself...

Make sure your bulb is priming foward as it should.

bassarama 06-07-2007 04:07 PM

Re: fuel/water filter
 
I just did one myself...

Make sure your bulb is priming foward as it should.

Shawsee 06-07-2007 05:55 PM

Re: fuel/water filter
 
Ok thanks guys. I did put some oil on the rubber seal. I did finally get it primed but it took forever. I now know that next time I will put fuel in the new filter before I even attempt to prime the bulb. Tomorrow is the "maiden voyage" and we are good to go.

Thanks again guys for your input & knowledge. This site is truly the best.

Shawsee 06-07-2007 05:55 PM

Re: fuel/water filter
 
Ok thanks guys. I did put some oil on the rubber seal. I did finally get it primed but it took forever. I now know that next time I will put fuel in the new filter before I even attempt to prime the bulb. Tomorrow is the "maiden voyage" and we are good to go.

Thanks again guys for your input & knowledge. This site is truly the best.


All times are GMT -5. The time now is 02:27 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.