|
|
|
|
#1
|
||||
|
||||
Bathroom remodel
My son bought a house built in 1955. It's bathroom had pink tile with black trim. I say had because we tore all the tile and wet plaster out except the ceiling. The sub floor is 1 x 6s run diagonally. We are going to use 1/2 inch backerboard and then thinset tile for the floor. My question is this. Should any type of subflooring be put down before the backer board? Thanks Billy Mac
Here is the bathroom before. I'll post the tear out photo tomorrow.  
__________________
 Now being pushed with the Force of an E-Tec! http://www.wellcraftv20.com/gallery/...1990-V20-Sport http://www.youtube.com/watch?v=9ESnJm4uxug Last edited by Mac_Attack; 04-04-2008 at 08:37 PM. 
|
|
#2
03-30-2008, 09:29 PM
|
||||
|
||||
|
sounds like a nice project billy , If your gonna put down 1/2 inch backer board use thin set under the backer board and use a 1/4 inch knotched trowel
__________________
1987 Dual Console / 2007 200 hp E-Tec 
|
|
#3
03-30-2008, 09:30 PM
|
||||
|
||||
|
oh going over the t&g shoud be fine , I would renail it before hand tho
__________________
1987 Dual Console / 2007 200 hp E-Tec
|
|
#4
03-30-2008, 09:50 PM
|
||||
|
||||
  
__________________
1987 Dual Console / 2007 200 hp E-Tec
|
|
#5
03-31-2008, 04:25 AM
|
||||
|
||||
|
LS your reply says to use thinset under the backer board. Why? I hope our project will look as good as yours. Billy Mac
__________________
Now being pushed with the Force of an E-Tec! http://www.wellcraftv20.com/gallery/...1990-V20-Sport http://www.youtube.com/watch?v=9ESnJm4uxug
|
|
#6
03-31-2008, 06:40 AM
|
||||
|
||||
|
putting the thinset under the backer board makes it super strong and it will keep the floor from flexing and causing the grout and or tile from cracking ..
mainly because you are going over 1x material if you were putting down a layer of plywood you could probabaly get away with out it
__________________
1987 Dual Console / 2007 200 hp E-Tec
|
 |
|
|
Hybrid Mode
