|
|
|
|
#1
|
|||
|
|||
Trim Gauge Installation
I have a 1996 Evinrude 200. I have two wires coming from the sending unit white/tan and black and tan. I have connected the white/tan to the signal input on the gauge and I' not sure where to connect the black/tan wire. The old gauge was not working and the black/tan wire was just hanging loose with a broken connector. I checked the sender and I'm getting the proper resistance. I tried to ground the black/tan to ground but it didn't work. I'm also using the adapter for 1986 controls since I just re-powered with a rebuilt 1996 200 Evinrude.
Thanks ahead of time!! Last edited by nmoss; 02-10-2008 at 08:30 PM. 
|
|
#2
02-10-2008, 08:54 PM
|
||||
|
||||
|
The black and tan goes to ground I believe IIRC.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
02-10-2008, 09:28 PM
|
|||
|
|||
|
I tried that. The thing pegs to the left when I ground the stupid wire.
|
|
#4
02-10-2008, 09:55 PM
|
|||
|
|||
|
on the trim sender you should only have two wires comming from in. a tan/white and then the short black wire grounds out to the bolt. the guage needs a 12v and a ground then put the tan white to the sig input. should work unless you have a guage thats for a yam or merc.
|
 |
|
|
Hybrid Mode
