|
|
|
|
#1
|
|||
|
|||
Cuddy Cabin Door Hardware
I'm wondering if anyone has any pictures (original equip or otherwise) of the hardware on the cuddy cabin sliding hatch and teak door. I stripped my boat's teak this weekend and refinished and I'm about to put it back on and I just can't justify re-rigging the nonsense that the previous owner had on the door. There's some garbage swivel latch on the top of the door where it attaches to the hatch and its WAY too big and looks gross. The bottom has a 'ship bolt' that's spring loaded, and actually works pretty well and there's a small door hook that keeps it from moving around when its open and a snap that keeps the two parts of the door together when its open. Its all very clunky and I'm interested in replacing some or all with a more simple and elegant solution.
Thanks! Last edited by thewaxmania; 06-08-2016 at 05:23 PM. 
|
|
#2
06-08-2016, 05:34 PM
|
||||
|
||||
|
sounds like original equipment to me.
__________________
1984 V20 "Express" & 2003 Suzuki DF140 (SOLD!) 2000 GradyWhite 265 Express YouTube/SkunkBoat https://www.youtube.com/channel/UC4F...znGospVOD6EJuw Transom Rebuild https://www.youtube.com/watch?v=EEz94NbKCh0 https://www.youtube.com/watch?v=Oe_ZmPOUCNc
|
|
#3
06-08-2016, 08:00 PM
|
|||
|
|||
|
Ah. So it came like that. I might just put another barrel bolt on the top. This latch system is pretty awful looking.
Thanks. Quote:
|
|
#4
06-09-2016, 10:04 AM
|
||||
|
||||
|
Sounds original like Skunk said. I did away with my door, but I think if I put another one on I'd try to make one that was a single piece and would swing all the way inside the cabin against the port side bulkhead to be out of the way when not needed.
Anyone who wants my factory cabin door is welcome to it, no charge.
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
 |
|
|
Hybrid Mode
