great deal in VA BEach area

deshet · #1 10-11-2006, 11:26 AM

I am buying a trailer off of a guy tonight.

But he has a V20 wellcraft sitting on it. The outboard is a 1986 150 evinrude
The boat has never been bottom painted
the transome is suppose to be a little weak but I have seen boat and believe that it has some years left.

Basically I am buying the trailer and he wants some to buy the outboard and take the rest for free.

You would have to redo the gas tank cover.

But it does have two new tanks holds about 80 gallons of fuel.

The guys seems honest but I have not heard the outboard run.

I am selling a dual axle aluminum trailer for $1500
You could properly get the wellcraft/engine for under $800

I will try and take pictures later.

thanks

C YENSEN · #2 10-11-2006, 11:31 AM

i am looking for a dually trailer post some pics

deshet · #3 10-11-2006, 11:48 AM

Quote:

Originally Posted by CYENSEN

i am looking for a dually trailer post some pics

here are pictures of my trailer with my boat on top

http://cgi.ebay.com/ebaymotors/1992-...QQcmdZViewItem

C YENSEN · #4 10-11-2006, 11:55 AM

thanks for the pics, but I am looking for rollers not bunks

thanks

macojoe · #5 10-11-2006, 12:25 PM

We have seen that boat before,

Whats with the 20' Baybreeze? *Its a 20' V20, there is no such animal (Baybreeze)

#6 10-11-2006, 03:44 PM

what year is the boat? i need winders bad. i'll give $300 for the windows. if he wont sell them that leaves $500 for outboard and rest of boat if anyone is interested! where is the boat located?

deshet · #7 10-11-2006, 04:29 PM

boat is a 1986

I think I am going to buy the whole things a try and sell it with my trailer since I will have an extra tralier lying around.

I also have a single axle roller trailer that I will sell for $1000. it is a 1998 no rust will hold a V20 with no problems also wheel bearings and tires are good.

Sitting on the trailer is a 1979 renken 19' with a 1984 70hp evinrude non trim and tilt. motor runs great boat has some soft spots in floor. Will let boat go with trailer for extra $200. Boat does not look good but I did pull in some 20+ pound stripper off of her last year.

deshet · #8 10-11-2006, 04:31 PM

macjoe

I did by the baybreeze

Runs great.

C YENSEN · #9 10-11-2006, 05:06 PM

THANKS BUT I GOT A SINGLE AXLE ROLLER, I WAS LOOKING FOR A DUALLY CAUSE I MIGHT START TRAILERING HER 5 HOURS FROM HERE.

msbhammer · #10 10-11-2006, 05:09 PM

Post pictures of the boat. I would buy the boat, pull the windows off the boat and cut them up in little pieces and mail them to RacerX, since he is robbing me of my bim top enclosure. * ;D ;D