|
|
|
|
#1
|
|||
|
|||
caulking
i took my boat out fishing this weekend and noticed where the ubolt is inside the cabin its wet, so im going to remove it and caulk it but im not sure if i should use 3m5200 or 3m4200 what do you surgest
__________________
love to fish 
|
|
#2
08-06-2008, 07:50 PM
|
||||
|
||||
|
if you are refering to the u bolt used as a bow eye that comes thru the bow into the anchor locker area I would use 5200. Permenant, watertight and you will not be removing it again. Plus it will be wet enough to say it is below the waterline.
if you are talking about something else above the waterline then 4200 would be fine and will allow you the ability to remove or alter it in the future.
__________________
Willy 1986 V20 Old School 1992 V20 1992 150 Yamaha 1997 HydraSport 2250 Vector 2009 17' G3 Outfitter "G Spot" http://www.youtube.com/watch?v=TDebw...eature=related "I won't be wronged, I won't be insulted and I won't be laid on a hand on. I don't do these things to others and I require the same from them" JW
|
|
#3
08-06-2008, 08:29 PM
|
||||
|
||||
|
also ck to see that the hull is solid there, there is a lot of weight there when pulling that boat up on the trailer. If not cracked or anything then 5200 be my choice also!
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#4
08-07-2008, 06:55 PM
|
|||
|
|||
|
thanks 5200 it is
__________________
love to fish
|
|
#6
08-08-2008, 08:22 PM
|
|||
|
|||
|
i know but i dont need the fast cure stuff, should i put it in the holes too when i take out the ubolt or should i just seal the plate and the bolt where it goes thru the plate, i dont want any water coming thru what do you think
__________________
love to fish
|
 |
|
|
Hybrid Mode
