|
|
|
|
#1
|
|||
|
|||
Second Question of the Day.
My tilt trim switch was mounted on the dash because the tilt/trim switch on the shifter is bad. I just picked up a spare one "shifter" and wondering how easy it is to install. The dash tilt/trim switch has three simple pulg in connections. Does the shifter control have the same set up, Simply plug the wires from the old switch into the shifter ????
Mike.
__________________
|
|
#2
01-31-2006, 06:05 PM
|
||||
|
||||
|
Re: Second Question of the Day.
yes all have a 3 wire set up. the colors is a common red/blue/green the handle will have the same. some I/O's have a 4th with but it's the trailer button.
__________________
 1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#3
01-31-2006, 06:07 PM
|
||||
|
||||
|
Re: Second Question of the Day.
you can add a 3 position switch any where on your boat for more ti'l trim switch locations. Just need a sping loaded back to off each way switch. i have one in the motor well on all my boats i build or restore. even if the motor has one i put one in the motor well so i can reach it inside or outside the rear of the boat.
__________________
1978 V20 Cuddy w/ 225 Johnson. And Several other boat's
|
|
#4
01-31-2006, 08:02 PM
|
||||
|
||||
|
Re: Second Question of the Day.
Damn Skools, that's a great idea.
Airslot
__________________
Airslot Airslot's V-20 Gallery
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
