|
|
#1
|
||||
|
||||
Resin
just did my first fiberglass repair. removed one of the rodholders on the transom, plugged it and glassed it over. gonna mount my downrigger there.
how long, in this weather will it take to set? i know its a bit chilly but its supposed to rain all day tomorrow. gotta get this heap in the water.
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha. 
|
|
#2
05-03-2008, 06:44 PM
|
||||
|
||||
|
You recogn that is why you been havin problems with the Marine Tex setting up?
Normally below 70° you have to about double the amoumt of hardner to make it set or bring the resin and hardner inside to get to room temperature or use a heat gun to warm the material to the temp that the stuff likes to start setting. Or move to a warmer climate. Suggest any, except the last. You wouldn't survive the sandgnats.
__________________
 '75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny
|
|
#3
05-03-2008, 08:27 PM
|
||||
|
||||
|
thanks tsub. that was very helpful.
any more insight?
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha.
|
|
#4
05-03-2008, 08:54 PM
|
||||
|
||||
|
Take you a hair dryer to the repair spot and get it hot. That will help it to kick off and cure quicker.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#5
05-03-2008, 11:16 PM
|
||||
|
||||
|
ok, i just shot it with a heatgun for about 5-8 minutes. of course, its raining now. my luck.
hope this works. dont wanna hafta do it again. (in the same spot).
__________________
hammer aint. stinkpot aint. sawdust aint. rainbow aint. maco sure as sh!t aint. randle? ha ha ha.
|
 |
|
|
Linear Mode
