So I'm getting the 135 ready to go on the boat. It sat for about 5 months and some how got water in the lower carb, it only showed traces of water in one cylinder. I evacuated the moisture took the carbs off and gave them a good cleaning. I put my carbs on today and put battery and gas to it. I first did my spark check and all 4 were firing HOT, i then compression checked and all 4 are showing exactly 150 psi ( my other gauge 5 months ago showed 130 on all 4 so one of my gauges is wrong) regardless all cylinders are even. But when I try to start it she's not firing!!!! So I pulled the plugs and 3 were wet with gas and one was dry as a bone. I figured I had an issue with that barrel on the carbs so I pulled the carbs and checked and she's clean as a whistle. I still don't understand why she's not firing on the other 3 cylinders that have fuel and fire!!!! On the cylinder that's dry, is the reed valves stuck? All advice is welcome.
evinrude 135hp not starting HELP
Threaded Mode