|
|
#1
|
||||
|
||||
will prop fit?
as i stated in the past, i am in the dark about outboards ... my sea drive came with a stainless prop ..
what are the chances that this prop will fit the motor i buy to replace the sea drive? looking at either yamaha or merc. are they a standard size, or is each manufacturer different? 
|
|
#2
06-11-2008, 07:29 PM
|
||||
|
||||
|
What sea-drive did you have before? Some can be made to interchange with a hub change, and some props use an interchangeable hub system which is the easiest to swap over.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#4
06-12-2008, 04:13 PM
|
||||
|
||||
|
The 1.6L sea-drive uses a 4" hub and a 13 spline prop shaft. They will fit some other V4's with a hub change, but they are meant for the 85-140 JOHNNY-RUDES(and some smaller 3 cylinders with oversized gear cases).
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664
|
 |
|
|
Linear Mode
