Center console replace or repair?

Just picked up a 75 v 20 center console has old gauge holes etc. any ideas on repair or where to find a new console for this boat?

[Skools Out]

cut out a large hole then set back in the dash with built box and install new gauges then lay a piece of lexan over the gauges hole and trim out with teak.

[randlemanboater]

There you go.


Or, there was a console on ebay the other day, dont know if its still there.

Yep, still there.

http://cgi.ebay.com/ebaymotors/Boat-...spagenameZWDVW

[cterrebonne]

i would cut out the wood from the back and reglass the wood from the back. then glass over the previous guage holes. then fair it out. and paint gel etc.

[pikfish]

If you are happy with the height and design of your console then cut out the entire top flat panel and replace it with lexan or plywood and glass over it. This is likely easier, better and quicker than trying to fix what you have.

[wpearch]

put up some phots so we can see what you got to work with

[Stillrunning]

Why can't you just fill the old holes with new gauges? Most are of common size.

When redoing old gauge consoles, I always use Starboard.

Just cut out the old & insert the Starboard then design the layout you want & cut the new holes....

Works good....

BlueH2O